Front Wiper Does Not Stop

CHECK CIRCUIT BETWEEN COMBINATION SWITCH AND BCM
With CONSULT-II
1. Select "BCM" on CONSULT-II, and select "WIPER" on "SELECT TEST ITEM" screen.
2. Select "DATA MONITOR" on "SELECT DIAG MODE" screen. Make sure that "FR WIPER INT""FR WIPER LOW""FR WIPER HI", and "FR WASHER SW" turn ON-OFF according to front wiper switch operation.
Without CONSULT-II

Refer to "COMBINATION SWITCH INSPECTION ".

OK or NG

OK : Replace IPDM E/R.

NG : Check combination switch (wiper switch). Refer to "COMBINATION SWITCH INSPECTION ".

Fig 1: CONSULT-II Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.