LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2006 >> FX35 RWD >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Wheel Hubs >> Rear Axle >> Rear Wheel Hub And Knuckle >> Disassembly and Assembly >> Assembly >> Wheel Bearing

Wheel Bearing

  1. Press fit a wheel hub into wheel bearing with a drift (SST).
    Fig 1: Identifying Wheel Hub Into Wheel Bearing
    G04076486Courtesy of NISSAN MOTOR CO., U.S.A.
    CAUTION:
    • Press fit a drift (SST) while holding it against wheel bearing inner side inner race.
    • Wheel bearing cannot be reused. Do not attempt to reuse it.
    NOTE: Final press load guideline 49,033 N (5,000 kg, 11,000 lb)
  2. Install back plate and wheel hub and bearing assembly.
  3. Install anchor block onto axle.
scientia non olet · About LEMON Manuals