LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2006 >> FX35 RWD >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Axle >> Rear Wheel Hub And Knuckle >> Disassembly and Assembly >> Disassembly >> Wheel Bearing

Wheel Bearing

CAUTION: Do not disassemble if wheel bearing has no trouble.
  1. Remove wheel bearing fixing bolts and anchor block fixing nuts, and remove wheel hub and bearing assembly, back plate and anchor block from axle.
  2. Using a drift (SST) and a puller (suitable tool), press wheel hub out to remove from wheel bearing.
    Fig 1: Identifying Wheel Hub Out To From Wheel Bearing
    G04076482Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Using a drift (SST) and a puller (suitable tool), press wheel bearing outer side inner race out to remove from wheel hub.
    Fig 2: Identifying Wheel Bearing Outer Side Inner Race Out To From Wheel Hub
    G04076483Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals