LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2006 >> FX35 RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System >> Rear Disc Brake >> Removal and Installation of Brake Caliper Assembly >> Installation

Removal and Installation of Brake Caliper Assembly: Installation

CAUTION:
  • Refill with new brake fluid "DOT 3".
  • Do not reuse drained brake fluid.
  1. Install disc rotor.
    CAUTION: Align the matching marks of disc rotor and wheel hub, which were marked at the time of removal when reusing disc rotor.
  2. Install caliper assembly to the vehicle, and tighten bolts to the specified torque. Refer to "COMPONENTS ".
    CAUTION: Before installing caliper assembly to the vehicle, wipe off oil and grease on washer seats on axle assembly and mounting surface of caliper assembly.
  3. Install brake hose to caliper assembly and tighten union bolt to the specified torque. Refer to "COMPONENTS ".
    CAUTION:
    • Do not reuse copper washer for union bolts.
    • Securely install brake hose to protrusion on caliper assembly.
  4. After installing caliper assembly, refill with new brake fluid and bleed air. Refer to "BLEEDING BRAKE SYSTEM ".
  5. Install tires to the vehicle.
scientia non olet · About LEMON Manuals