Inspection After Removal: Notes

Make sure the rivets in the upper part of brake pedal are not deformed.
Make sure that joint length "L" of sub-bracket and sliding plate is 5.5 mm (0.217 in) or more.
Replace brake pedal assembly if any non-standard condition is detected.

Fig 1: Identifying Joint Length
Courtesy of NISSAN MOTOR CO., U.S.A.
Check clevis pin and plastic stopper for damage and deformation. Replace clevis pin if there are.

Fig 2: Identifying Clevis Pin And Plastic Stopper For Damage
Courtesy of NISSAN MOTOR CO., U.S.A.