LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2006 >> FX35 RWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System >> Brake Booster >> Removal and Installation >> Removal

Removal and Installation: Removal

CAUTION:
  • Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted surfaces of body, immediately wipe it off and them wash it away with water immediately.
  • Be careful not to deform or bend brake tube while removing and installing brake booster.
  • Replace clevis pin if it is damaged.
  • Be careful not to damage brake booster stud bolt threads. If brake booster is tilted or inclined during installation, dash panel may damage the threads.
  • Install the check valve in the correct direction.
  1. Remove vacuum hose from brake booster. Refer to "VACUUM LINES ".
  2. Remove brake master cylinder. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect harness connector from brake booster assembly. (ICC model)
  4. Remove snap pin and clevis pin from inside the vehicle. Refer to "COMPONENTS ".
  5. Remove nuts from brake booster and brake pedal bracket.
  6. Remove brake booster assembly from engine room.
scientia non olet · About LEMON Manuals