Erase Memory
- Turn ignition switch OFF.
- Start the engine and touch "ABS""SELF-DIAG RESULTS""ERASE MEMORY" in order on the CONSULT-II screen to erase the error memory.CAUTION: If the error memory is not erased, re-conduct the operation from step 4.
- Perform self-diagnosis again, and make sure that diagnostic memory is erased.
- Drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute as the final inspection, and make sure that the ABS warning lamp, VDC OFF indicator lamp and SLIP indicator lamp turn off.NOTE: VDC OFF switch should not stay "ON" position.