DTC C1160

INSPECTION PROCEDURE

1. CHECK SELF- DIAGNOSTIC RESULTS (1) 

   Check self-diagnostic results.

   SELF-DIAGNOSTIC RESULTS CHART
   
   

   Self-diagnostic results
   DECEL G SEN SET

   Does anything besides "DECEL G SEN SET" appear on self-diagnostic results display?

   YES : Inspect and repair the indicated items. Then perform self-diagnosis again.

   NO : Perform calibration of decel G sensor. Then GO TO 2.

2. CHECK SELF-DIAGNOSIS RESULTS (2) 

   Turn ignition switch OFF and ON to erase self-diagnostic results, and perform ABS actuator and electric unit (control unit) self-diagnosis again.

   Does anything appear on self-diagnostic results display?

   YES : Replace yaw rate/side/decel G sensor. Then perform calibration of decel G sensor and perform self-diagnosis again.

   NO : INSPECTION END