Lid Weatherstrip Overlap Adjustment And Surface Mismatch Adjustment
- Tilt up glass lid.
- After loosening glass lid TORX bolts (T25) (left and right), tilt down glass lid.
- Adjust glass lid from outside of vehicle so it resembles "A-A" "B- B" "C-C" as shown in the figure to the right.
- To prevent glass lid from moving after adjustment, first tighten the TORX bolts (T25) of front left, and then tighten the TORX bolts (T25) of rear right.
- Tighten remaining TORX bolts (T25), being careful to prevent glass lid from moving.
- Tilt glass lid up and down several times to make sure it moves smoothly.
Courtesy of NISSAN MOTOR CO., U.S.A.