LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2006 >> FX35 RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper, Washer & Horn >> Front Wiper And Washer System >> After Front Wiper Operate for 10 Seconds, They Stop for 20 Seconds, and After Repeating the Operations Five Times, They Become Inoperative

After Front Wiper Operate for 10 Seconds, They Stop for 20 Seconds, and After Repeating the Operations Five Times, They Become Inoperative

CAUTION:
  • When auto-stop signal has not varied for 10 seconds or longer while IPDM E/R is operating front wipers, IPDM E/R considers that front wipers are locked, and stops wiper output. That causes this symptom.
  • This status can be checked by "DATA MONITOR" of "IPDM E/R" on which "WIPER PROTECTION" item shows "BLOCK".
  1. CHECK WIPER MOTOR SIGNAL 

    With CONSULT-II

    Select "IPDM E/R" by CONSULT-II. With "DATA MONITOR", make sure that "WIP AUTO STOP" turns "ACT P" - "STOP P" linked with wiper operation.

    Without CONSULT-II

    GO TO 2.

    OK or NG 

    OK : Replace IPDM E/R.

    NG : GO TO 2.

    Fig 1: CONSULT-II Display - Data Monitor
    G04078704Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK WIPER AUTO STOP CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect IPDM E/R connector and front wiper motor connector.
    3. Check continuity between IPDM E/R harness connector E7 terminal 32 and front wiper motor harness connector E57 terminal 5.

      32 - 5 : Continuity should exist. 

    4. Check continuity between IPDM E/R harness connector E7 terminal 32 and ground.

      32 - Ground : Continuity should not exist. 

      Fig 2: Identifying Continuity Between IPDM E/R Harness Connector E7 Terminal 32 And Ground
      G04078705Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK : GO TO 3.

    NG : Repair harness or connector.

  3. CHECK FRONT WIPER MOTOR 
    1. Connect IPDM E/R connector and front wiper connector.
    2. Turn ignition switch ON.
    3. Check voltage between IPDM E/R harness connector E7 terminal 32 and ground while front wiper motor is stopped and while it is operating.
      IPDM E/R CONNECTOR TERMINAL VOLTAGE REFERENCE

      (+) (-) Condition Voltage
      IPDM E/R connector Terminal
      E7 32 Ground Wiper stopped Approx. 0 V
      Wiper operating Battery voltage

    OK or NG 

    OK : Replace IPDM E/R.

    NG : Replace front wiper motor.

    Fig 3: Identifying Voltage Between IPDM E/R Harness Connector E7 Terminal 32 And Ground
    G04078706Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals