Disassembly and Assembly: Disassembly
- Place the mirror body with mirror glass facing upward.
- Put strip of protection tape on mirror body.
- As shown in the figure insert a small flat-bladed screwdriver into the recess between mirror base (mirror holder) and mirror holder bracket and push up pawls to remove mirror holder lower half side.
NOTE: When pushing up pawls do not attempt to use 1 recess only, be sure to push up with both recesses.
Insert screwdriver into recesses, and push up while rotating (twist) to make work easier.
- Remove terminals of mirror heater attachment.
- Lightly lift up lower side of mirror surface, and detach pawls of upper side from bracket as if pulling it out.
Remove mirror surface from mirror body.
NOTE: Be certain not to allow grease on sealing agent in center of mirror body assembly (actuator) or back side of mirror surface (mirror holder).