Power Supply And Ground

Power is supplied at all time

• through 10A fuse [No. 19, located in fuse block (J/B)]
• to rear view camera control unit terminal 1.

When ignition switch is in ACC or ON position, power is supplied

• through 10A fuse [No. 6, located in fuse block (J/B)]
• to rear view camera control unit terminal 2.

When ignition switch is in ON or START position, power is supplied

• through 10A fuse (No. 83, located in IPDM E/R)
• to back-up lamp relay terminals 1 and 3.

Ground is supplied

• to rear view camera control unit terminal 3
• through grounds M35, M45 and M85.