Washer Operation
With the ignition switch in the ON or START position, power is supplied
- Through 20A fuse [No. 34, located in fuse block (J/B) No. 2]
- To front washer motor terminal 1.
When the front wiper switch in the WASH position, ground is supplied
- To front washer motor terminal 2
- To BCM terminal 4
- From front wiper switch terminal 18
- Through front wiper switch terminal 17
- Through grounds M25 and M115.
With power and ground supplied, the front washer motor operates. The front wiper motor operates at low speed for about 3 seconds. This feature is controlled by the BCM in the same manner as the intermittent operation.