Consult-II Basic Operation

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which perform CAN communication.

With ignition switch OFF, connect "CONSULT-II" and "CONSULT-II CONVERTER" to data link connector, and turn ignition switch ON.

Fig 1: Identifying Data Link Connector And Hood Opener Handle
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "START (NISSAN BASED VHCL)".

Fig 2: START - CONSULT II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "IVMS".
If "IVMS" is not indicated, Refer to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

Fig 3: IVMS - CONSULT II Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "WITH SUNROOF" on "SELECT SYS COND" screen.
Touch "OK". If the selection is wrong, touch "CANCEL".
Select the desired part to be diagnosed on "SELECT TEST ITEM" screen.

Fig 4: WITH SUNROOF - CONSULT II Display
Courtesy of NISSAN MOTOR CO., U.S.A.