Power Supply and Ground Circuit Inspection

CHECK FUSE
Check for blown combination meter fuses.

Fig 1: Combination Meter Check Fuse Table
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG
1. OK: GO TO 2.
2. NG: If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
CHECK POWER SUPPLY CIRCUIT
Check voltage between combination meter harness connector M19 terminals 18 (LG), 21 (R/W), 22 (G/Y), 23 (G/Y) and ground.

Fig 2: Combination Meter Harness Connector M19 Terminals And Ground Voltage Table
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Checking Voltage Between Combination Meter Harness Connector M19 Terminals And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG
1. OK: GO TO 3.
2. NG: Check harness between combination meter and fuse.
CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect combination meter connector.
3. Check continuity between combination meter harness connector M19 terminals 1 (B), 24 (B), 25 (B) and ground.
  1(B) - Ground
  
  24(B) - Ground: Continuity should exist.
  
  25(B) - Ground
OK or NG
1. OK: INSPECTION END
2. NG: Repair ground harness.
  
  Fig 4: Checking Continuity Between Combination Meter Harness Connector M19 Terminals And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.