Turn Signal Lamp Does Not Operate

CHECK BULB
Check bulb standard of each turn signal lamp is correct.

OK or NG
1. OK: GO TO 2.
2. NG: Replace turn signal lamp bulb.
CHECK COMBINATION SWITCH INPUT SIGNAL
With CONSULT-II

Select "BCM" on CONSULT-II. With "FLASHER" data monitor, make sure "TURN SIGNAL R" and "TURN SIGNAL L" turns ON-OFF linked with operation of lighting switch.

When lighting switch is: TURN SIGNAL R ON TURN RH position

When lighting switch is: TURN SIGNAL L ON TURN LH position

Without CONSULT-II

Refer to "COMBINATION SWITCH INSPECTION ".

OK or NG
1. OK: GO TO 3.
2. NG: Check combination switch (lighting switch). Refer to "COMBINATION SWITCH INSPECTION ".
  
  Fig 1: CONSULT-II Data Monitor Display Screen
  Courtesy of NISSAN MOTOR CO., U.S.A.
ACTIVE TEST
With CONSULT-II
1. Select "FLASHER" during active test. Refer to "ACTIVE TEST ".
2. Make sure "FLASHER RIGHT" and "FLASHER LEFT" operates.
  Turn signal lamp should operate
Without CONSULT-II

GO TO 4.

OK or NG
1. OK: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".
2. NG: GO TO 4.
  
  Fig 2: CONSULT-II Active Test Display Screen
  Courtesy of NISSAN MOTOR CO., U.S.A.
CHECK SHORT CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BCM connector and all turn signal lamp connectors.
3. Check continuity (short circuit) between BCM harness connector and ground.
  
  Fig 3: Continuity Table Of BCM Harness Connector And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  Fig 4: Checking Continuity (Short Circuit) Between BCM Harness Connector And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: Replace BCM if turn signal lamps does not work after setting the connector again. Refer to "REMOVAL AND INSTALLATION OF BCM ".
2. NG: Repair harness or connector.