Remote Keyless Entry System Operation

Power is supplied at all times

through 50A fusible link (letter F, located in fuse, fusible link and relay box)
to BCM terminal 55,
through 10A fuse [No. 19, located in fuse block (J/B)]
to combination meter terminal 21.

Ground is supplied

to BCM terminal 52
through grounds M30 and M66,
to combination meter terminals 1, 24 and 25
through grounds M30 and M66.

When the remote keyless entry system is triggered by input from key fob, BCM supplies power

through BCM terminal 45
to front combination lamp LH terminal 6, and
to rear combination lamp LH terminal 3,
through BCM terminal 46
to front combination lamp RH terminal 6, and
to rear combination lamp RH terminal 3.

Ground is supplied

to front combination lamp LH terminal 4, and
to front combination lamp RH terminal 4
through grounds E17 and E43,
to rear combination lamp LH terminal 4, and
to rear combination lamp RH terminal 4
through ground B103.

The BCM also supplies input to combination meter terminals 4 and 5 across CAN communication lines. This input is processed by unified meter control unit in combination meter, which in turn supplies ground to the left and right turn signal indicator lamps.

With power and ground supplied, BCM controls flashing of hazard warning lamps when key fob is used to activate remote keyless entry system.