Front Turn Signal/Parking Lamp
- Turn lighting switch OFF.
- Remove fender protector (front). Refer to "FENDER PROTECTOR " in Exterior & Interior article.
- Turn bulb socket counterclockwise and unlock it.
- Remove bulb from its socket.
- Installation is the reverse order of removal.
Headlamp (upper) low beam: 12V - 35W (D2R)
Headlamp (lower) high beam/Fog lamp: 12V - 60/55W (HB2)
Front turn signal/Parking lamp: 12V - 21/5W
CAUTION: After installing bulb, be sure to install plastic cap and bulb socket securely to insure watertightness.