Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal noting the following:

For models equipped with the 5 A/T, tighten the two LH transaxle mounting insulator bolts to specification.
Install the stabilizer bar bushings and clamps in the specified orientation. Refer to "REMOVAL AND INSTALLATION ".
Tighten the stabilizer bar and connecting rod nuts and bolts to specification. Refer to "COMPONENTS ".
Tighten the steering gear mounting bolts to specification. Refer to "REMOVAL AND INSTALLATION - - STEERING GEAR MOUNTING BOLTS ".
Check the wheel alignment. Refer to "FRONT WHEEL ALIGNMENT ".