Possible Causes of "Auto-Cancel"
WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
POSSIBLE CAUSES OF AUTO-CANCEL
| Cause of cancellation | Description |
|---|---|
| OPERATING WIPER | Windshield wipers were operated at HI or LO speed operation. |
| OPERATING ABS | ABS function was operated. |
| OPERATING TCS | TCS function was operated. |
| OPERATING VDC | VDC function was operated. |
| ECM CIRCUIT | ECM did not permit ICC operation. |
| OPE SW VOLT CIRC | Voltage outside the standard was detected. |
| LASER SUN BEAM | Intense light such as sunlight entered ICC sensor light sensing part. |
| LASER TEMP | Temperature around ICC sensor became low. |
| WHLSPD ELEC NOISE | Wheel speed sensor signal caught electromagnetic noise. |
| OP SW DOUBLE TOUCH | ICC steering switches were pressed at the same time. |
| VDC/TCS OFF SW | VDC OFF switch was pressed. |
| WHEEL SPD UNMATCH | Wheel speed became different from AT vehicle speed. |
| TIRE SLIP | Wheel slipped. |
| PKB SW ON | Parking brake is applied. |
| IGN LOW VOLT | Power supply voltage became low. |
| NO RECORD | - |