Removal and Installation: Removal
WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Never apply tack-paper adhesive remover to body panel surface finished with lacquer-based paints.
- Original over fenders are affixed to body panel with double-faced adhesive tape and plastic clips.
- Heat side guard molding to between 30° and 40°C (86 to 104°F) with a heat gun.
- Raise end of side guard molding, cut away double-faced adhesive tape and release clips to remove side guard molding.
- Remove all traces of double-faced adhesive tape.