LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2004 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1225 (Exterior & Interior) >> Rear Spoiler >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove back door trim. Refer to "BACK DOOR TRIM ".
  2. Disconnect harness to high-mount stop lamp.
  3. Disconnect washer tube.
  4. Remove nuts, release clips and remove rear spoiler.
    • Release adhesive tape with sawing motion from monofilament line that has knots in it.
    • Remove residue of adhesive tape completely from vehicle surface with strip-off wheel or equivalent.
      CAUTION:
      • Never apply tack-paper adhesive remover to body panel surface finished with lacquer-based paints.
      • Use care not to damage the vehicle surface during adhesive tape residue removal.
  5. Remove nuts and remove high-mount stop lamp.
scientia non olet · About LEMON Manuals