LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2004 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1225 (Exterior & Interior) >> Over Fender >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove screws from front and/or rear over fender.
    CAUTION: Never apply tack-paper adhesive remover to body panel surface finished with lacquer-based paints.
    • Original over fenders are affixed to body panel with double-faced adhesive tape.
  2. Heat over fender to between 30° and 40°C (86° to 104°F) with a heat gun.
  3. Raise end of over fender and cut away tape, release plastic clips and remove over fender. Remove all traces of tape.
scientia non olet · About LEMON Manuals