Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

On vehicles coated with Hard Clear Coat, use double-faced 3M adhesive tape Product No, 4210 or equivalent, after priming with 3M primer Product No. N200, C-100 or equivalent.
The repair parts are also affixed with double-faced adhesive tape.
To re-use existing over fender, clean all traces of double-faced tape from the over fender and apply new double-faced tape to the over fender.

Clean the panel surface with isopropyl alcohol or equivalent to degrease the surface.
Heat the panel and double-faced tape surface to 30° to 40°C (86° to 104°F).
Remove the backing sheet from the tape surface.
Align the plastic clips on the back side of the front and/or rear over fender to the mounting grommets.
Press ends by hand and use a roller to apply 5 kg-f (11 lbs-f) to press over fender surface to body panel.
CAUTION: To secure contact, do not wash vehicle for 24 hours after installation.
Secure front and/or rear over fender with screws.