LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2004 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1222 (Body, Lock & Security System) >> Hood >> Fitting Adjustment >> Clearance And Surface Height Adjustment

Clearance And Surface Height Adjustment

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hood lock assembly and adjust the height by rotating the bumper rubber until the hood clearance of hood and fender becomes 1 mm (0.04 in) lower than fitting standard dimension.
  2. Temporarily tighten the hood lock, and position it by engaging it with the hood striker. Check the lock and striker for looseness, and tighten the lock mounting bolt to the specified torque.
  3. Adjust the clearance and surface height of hood and fender according to the fitting standard dimension by rotating right and left bumper rubbers.
CAUTION: Adjust right/left gap between hood and each part to the following specification.
  1. Hood and headlamp (B-B): Less than 2.0 mm
scientia non olet · About LEMON Manuals