LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2004 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1221 (Supplemental Restraint System) >> Side Air Bag (Satellite) Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
  1. Remove seat belt pre-tensioner. Refer to "REMOVAL AND INSTALLATION OF FRONT SEAT BELT ".
  2. Remove side air bag (satellite) sensor nuts.
  3. Disconnect the side air bag (satellite) sensor harness connector.
    Fig 1: Side Air Bag (Satellite) Sensor With Torque Specifications
    G02386179Courtesy of NISSAN MOTOR CO., U.S.A.
CAUTION:
  • Do not use old nuts after removal; replace with new nuts.
  • Check side air bag (satellite) sensor to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it with new one.
  • Do not disassemble side air bag (satellite) sensor.
  • Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.