Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

CAUTION: To install, use a flare nut wrench (commercial tool).

Always tighten brake tubes to specification when installing. Refer to "BRAKE PIPING AND HOSE ".
Never reuse drained brake fluid.
After installation of the ABS actuator and electric unit (control unit), perform the following.
- Refill brake system with new brake fluid. Then bleed the air from the system. Refer to "BLEEDING BRAKE SYSTEM ".
- Adjust the steering angle sensor. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION ".
- Calibrate the decel G sensor. Refer to "CALIBRATION OF YAW RATE/SIDE/DECEL G SENSOR ".