Removal and Installation: Removal
WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately.
- Before removing brake master cylinder, depress the brake pedal 5-6 times with the key OFF to deplete vacuum in the booster.
- Drain brake fluid. Refer to "DRAIN AND REFILL ".
- Disconnect harness connectors for fluid level sensor and pressure sensors.
- Using a flare nut wrench, disconnect brake tube from brake master cylinder.
- Remove brake master cylinder mounting nuts, and master cylinder assembly.