Malfunction Code/Symptom Chart
WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
MALFUNCTION CODE/SYMPTOM CHART
| Code/Symptom | Malfunction part | References |
|---|---|---|
| 15 | Front-left tire pressure drops to 193 kPa (2.0 kg/cm2 , 28 psi) or less | |
| 16 | Front-right tire pressure drops to 193 kPa (2.0 kg/cm2 , 28 psi) or less | |
| 17 | Rear-right tire pressure drops to 193 kPa (2.0 kg/cm2 , 28 psi) or less | |
| 18 | Rear-left tire pressure drops to 193 kPa (2.0 kg/cm2 , 28 psi) or less | |
| 21 | Transmitter no data (front - left) | "INSPECTION 1: TRANSMITTER OR CONTROL UNIT (BCM) " |
| 22 | Transmitter no data (front - right) | |
| 23 | Transmitter no data (rear - right) | |
| 24 | Transmitter no data (rear - left) | |
| 31 | Transmitter checksum error (front - left) | "INSPECTION 2: TRANSMITTER - 1 " |
| 32 | Transmitter checksum error (front - right) | |
| 33 | Transmitter checksum error (rear - right) | |
| 34 | Transmitter checksum error (rear - left) | |
| 35 | Transmitter pressure data error (front - left) | "INSPECTION 3: TRANSMITTER - 2 " |
| 36 | Transmitter pressure data error (front - right) | |
| 37 | Transmitter pressure data error (rear - right) | |
| 38 | Transmitter pressure data error (rear - left) | |
| 41 | Transmitter function code error (front - left) | "INSPECTION 2: TRANSMITTER - 1 " |
| 42 | Transmitter function code error (front - right) | |
| 43 | Transmitter function code error (rear - right) | |
| 44 | Transmitter function code error (rear - left) | |
| 45 | Transmitter battery voltage low (front - left) | "INSPECTION 2: TRANSMITTER - 1 " |
| 46 | Transmitter battery voltage low (front - right) | |
| 47 | Transmitter battery voltage low (rear - right) | |
| 48 | Transmitter battery voltage low (rear - left) | |
| 52 | Vehicle speed signal | "INSPECTION 4: VEHICLE SPEED SIGNAL " |
| Low tire pressure warning lamp does not come on when ignition switch is turned on. | Fuse or combination meter BCM connector or circuit BCM | "INSPECTION 1: WARNING LAMP DOES NOT COME ON WHEN IGNITION SWITCH IS TURNED ON " |
| Low tire pressure warning lamp stays on when ignition switch is turned on. | Combination meter BCM connector or circuit BCM | "INSPECTION 2: WARNING LAMP STAYS ON WHEN IGNITION SWITCH IS TURNED ON " |
| Low tire pressure warning lamp flashes when ignition switch is turned on. | BCM harness connector or circuit BCM Transmitter's mode off ID registration not yet | "INSPECTION 3: WARNING LAMP FLASHES WHEN IGNITION SWITCH IS TURNED ON " |
| Hazard warning lamp flashes when ignition switch is turned on. | BCM harness connector or circuit BCM | "INSPECTION 3: WARNING LAMP FLASHES WHEN IGNITION SWITCH IS TURNED ON " |
| "TIRE PRESSURE" information in display does not exist. | Fuse Display unit BCM | "Inspection 5: "TIRE PRESSURE " Information In Display Unit Does Not Exist" |
| ID registration cannot be completed. | Transmitter Remote keyless entry receiver harness connector or circuit Remote keyless entry receiver BCM harness connector or circuit BCM | "INSPECTION 6: ID REGISTRATION CANNOT BE COMPLETED " |