Wheel Alignment (Unladen )
WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
Service Data And Specifications - Wheel Alignment
| Drive type | 4x2 | 4x4 | ||||||||||||
| Camber Degree minute (decimal degree) |
Minimum | -0° 51' (-0.85°) | -0° 34' (-0.57°) | |||||||||||
| Nominal | -0° 6' (-0.10°) | 0° 11' (0.18°) | ||||||||||||
| Maximum | 0° 39' (0.65°) | 0° 56' (0.93°) | ||||||||||||
| Cross camber | 0° 45' (0.75°) or less | 0° 45' (0.75°) or less | ||||||||||||
| Caster Degree minute (decimal degree) |
Minimum | 3° 7' (3.12°) | 2° 41' (2.68°) | |||||||||||
| Nominal | 3° 52' (3.87°) | 3° 26' (3.43°) | ||||||||||||
| Maximum | 4° 37' (4.62°) | 4° 11' (4.18°) | ||||||||||||
| Cross caster | 0° 45' (0.75°) or less | 0° 45' (0.75°) or less | ||||||||||||
| Kingpin inclination Degree minute (decimal degree) |
13° 32' (13.53°) | 13°13' (13.22°) | ||||||||||||
| Total toe-in | Distance (A - B) | Minimum | 1.8 mm (0.07 in) | 1.8 mm (0.07 in) | ||||||||||
| Nominal | 2.8 mm (0.11 in) | 2.8 mm (0.11 in) | ||||||||||||
| Maximum | 3.8 mm (0.15 in) | 3.8 mm (0.15 in) | ||||||||||||
| Angle (left side and right side) Degree minute (decimal degree) | Minimum | 0° 3' (0.05°) | 0° 3' (0.05°) | |||||||||||
| Nominal | 0° 5' (0.08°) | 0° 5' (0.08°) | ||||||||||||
| Maximum | 0° 7' (0.12°) | 0° 7' (0.12°) | ||||||||||||
| Wheel turning angle (full turn) | Inside Degree minute (decimal degree) |
34° 31'- 38° 31' (2) (34.52° -38.52°) | 34° 44'- 38°44'(4) (34.73°-38.73°) | |||||||||||
| Outside Degree minute (decimal degree) | 30° 59' - 34° 59' (3) (30.98°-34.98°) | 30° 29' - 34° 29' (5) (30.48° - 34.48°) | ||||||||||||
|
||||||||||||||