Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Inspect the ABS sensor O-ring, replace the ABS sensor assembly if damaged.
Clean the ABS sensor hole and mounting surface with a suitable brake cleaner and a clean lint-free shop rag. Be careful that dirt and debris do not enter the axle bearing area.
Apply a coat of suitable grease to the ABS sensor O-ring and mounting hole.
Use a new cotter pin for installation.
Use new wheel hub and bearing assembly bolts for installation.