Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Do not reuse the drive shaft inside flange bolts and washers, discard after removal and use new bolts and washers for installation.
Do not reuse the cotter pin, discard after removal and use a new cotter pin for installation.
1. Drive shaft lock nut: Refer to , "REMOVAL AND INSTALLATION ".
2. Drive shaft inside flange bolts: Refer to "COMPONENTS ".