General Specifications
WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
4X2 Model
GENERAL SPECIFICATIONS (4X2 MODEL) - SERVICE DATA AND SPECIFICATIONS
| Applied model | VK56DE |
|---|---|
| Propeller shaft model | 2S1350 |
| Number of joints | 2 |
| Coupling method with rear final drive | Flange type |
| Coupling method with transmission | Sleeve type |
| Shaft length (Spider to spider) | 1640 mm (64.57 in) |
| Shaft outer diameter | 127.6 mm (5.02 in) |
| Journal axial play | 0.02 mm (0.0008 in) or less |
| Propeller shaft run out limit | 1.02 mm (0.0402 in) or less |
| Propeller shaft joint flex effort | 2.26 N.m (0.23 kg-m, 20 in-lb) or less |
4X4 Model
General Specifications (4X4 Model) - Service Data And Specifications
| Applied model | VK56DE | |
| Propeller shaft model | Front | Rear |
| 2F1310 | 2S1350 | |
| Number of joints | 2 | |
| Coupling method with front final drive | Flange type | |
| Coupling method with transfer | Flange type | Sleeve type |
| Shaft length (Spider to spider) | 718 mm (28.27 in) | 1640 mm (64.57 in) |
| Shaft outer diameter | 63 5 mm (2.5 in) | 127.6 mm (5.02 in) |
| Journal axial play | 0.02 mm (0.0008 in) or less | |
| Propeller shaft run out limit | 0.6 mm (0.024 in) or less | 1.02 mm (0.0402 in) or less |
| Propeller shaft joint flex effort | 1.96 N.m (0.20 kg-m, 17 in-lb) or less | 2.26 N.m (0.23 kg-m, 20 in-lb) or less |