Cruise Test

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

CHECK INPUT SIGNAL
1. Warm up engine to normal operating temperature.
2. Park vehicle on flat surface.
3. Move A/T selector lever to "P" position.
4. Set 4WD shift switch to "AUTO" position.
5. Start engine.
6. Drive vehicle for at least 30 seconds at a speed higher than 20 km/h (12 MPH).
Check 4WD warning lamp turned ON?
1. On steady: Perform the self-diagnosis. Refer to "SELF-DIAGNOSTIC PROCEDURE (WITH CONSULT-II) " (with CONSULT-II) or "SELF-DIAGNOSTIC PROCEDURE (WITHOUT CONSULT-II) " (without CONSULT-II).
2. Flash rapidly: GO TO "4WD WARNING LAMP FLASHES RAPIDLY ".
3. Flash slowly: GO TO "4WD WARNING LAMP FLASHES SLOWLY ".
4. NO: GO TO 2.
CHECK TIGHT CORNER BRAKING SYMPTOM (1)
1. Set 4WD shift switch to "AUTO" position.
2. Drive vehicle at speed lower than 20 km/h (12 MPH) with steering wheel fully turned.
Does tight corner braking symptom occur?
1. YES: GO TO "HEAVY TIGHT-CORNER BRAKING SYMPTOM OCCURS ".
2. NO: GO TO 3.
CHECK TIGHT CORNER BRAKING SYMPTOM (2)
1. Set 4WD shift switch to "4HI" position.
2. Drive vehicle at speed lower than 20 km/h (12 MPH) with steering wheel fully turned.
Does tight corner braking symptom occur?
1. YES: Inspection End.
2. NO: GO TO "4WD SYSTEM DOES NOT OPERATE ".