Component Inspection

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch "OFF". (Stay for at least 5 seconds.)
Disconnect neutral-4LO switch harness connector.
Remove neutral-4LO switch. Refer to "LOCATION OF ELECTRICAL PARTS ".
Push and release neutral-4LO switch and check continuity between neutral-4LO switch terminals 12 and 13.

Fig 1: Neutral-4LO Switch Terminals 12 And 13 Continuity Specifications
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Checking Continuity Between Neutral-4LO Switch Terminals 12 And 13
Courtesy of NISSAN MOTOR CO., U.S.A.
If NG, replace the neutral-4LO switch. Refer to "LOCATION OF ELECTRICAL PARTS ".