With Consult-II
WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch "ON". (Do not start engine.)
- Select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
- Start engine.
- Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.
Selector lever: "1" or "2"
Gear position: "1st" or "2nd" gear (LC/B ON/OFF)
- If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".