Inspection After Installation
WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
- Before starting the engine, check oil/fluid levels including engine coolant and engine oil. If the levels are lower than required quantity, fill to the specified level. Refer to "RECOMMENDED FLUIDS AND LUBRICANTS ".
- Use procedure below to check for fuel leakage.
- Turn ignition switch ON (with engine stopped). With fuel pressure applied to the fuel piping, check for fuel leakage at the connection points.
- Start engine. With engine speed increased, check again for fuel leakage at connection points.
- Run engine to check for unusual noise and vibration.
- Warm up engine thoroughly to make sure there is no leakage of fuel, exhaust gas, or any oils/fluids including engine oil and engine coolant.
- Bleed air from passages in lines and hoses, such as in cooling system.
- After cooling down the engine, again check oil/fluid levels including engine oil and engine coolant. Refill to specified level if necessary.
- Summary of the inspection items:INSPECTION ITEM CONDITIONS
Item Before starting Engine running After engine stopped Engine coolant Level Leakage Level Engine oil Level Leakage Level Other oils and fluids Level Leakage Level Fuel Leakage Leakage Leakage Exhaust gas - Leakage - (1) Transmission/transaxle/CVT fluid, power steering fluid, brake fluid, etc.