LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2004 >> QX56 RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1200 (Engine Mechanical) >> Cylinder Block >> How to Select Piston and Bearing >> How To Select Connecting Rod Bearing >> When Crankshaft and Connecting Rod are Reused

When Crankshaft and Connecting Rod are Reused

WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure dimensions of the big end inside diameter of the connecting rod and diameter of the crankshaft pin individually.
  2. Apply the measured dimension to the "Connecting Rod Bearing Selection Table".
  3. The following steps are the same as in "When New Connecting Rod and Crankshaft are Used". Refer to PISTON SELECTION TABLE .
scientia non olet · About LEMON Manuals