CONSULT-II Inspection Procedure

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

Turn ignition switch OFF.
Insert IVIS (NATS) program card into CONSULT-II.
Program card: NATS (AEN01C-1)
Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.

Fig 1: Locating Data Link Connector

G02249238

Courtesy of NISSAN MOTOR CO., U.S.A.

Turn ignition switch ON.
Touch "START (NISSAN BASED VHCL)".

Fig 2: Identifying CONSULT-II Screen

G02249239

Courtesy of NISSAN MOTOR CO., U.S.A.

Touch "OTHER"

Fig 3: Identifying CONSULT-II SELECT VEHICLE Screen

G02249240

Courtesy of NISSAN MOTOR CO., U.S.A.

Select "NATS V.5.0".
If "NATS V5.0" is not indicated, go to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .

Fig 4: Identifying CONSULT-II SELECT SYSTEM Screen

G02249241

Courtesy of NISSAN MOTOR CO., U.S.A.

Perform each diagnostic test mode according to each service procedure.

For further information, see the CONSULT-II Operation Manual NATS-IVIS/NVIS.

Fig 5: Identifying CONSULT-II SELECT DIAG MODE Screen

G02249242

Courtesy of NISSAN MOTOR CO., U.S.A.