Preliminary Check For Thermometer
- COOL DOWN CHECK
- Turn the ignition switch to the ON position.
- Cool down the ambient sensor with water or ice.
Does the indicated temperature drop?
- Yes: GO TO 2.
- No: The system is malfunctioning. Refer to INSPECTION/COMPASS AND THERMOMETER
- WARM UP CHECK
- Leave the vehicle for 10 minutes.
- With the ignition switch in the ON position, disconnect and reconnect the ambient sensor connector.
Does the indicated temperature rise?
- Yes: The system is OK.
- No: The system is malfunctioning. Refer to INSPECTION/COMPASS AND THERMOMETER .
NOTE:- The indicated temperature on the thermometer is not readily affected by engine heat. It changes only when one of the following conditions is present.
- The temperature detected by the ambient sensor is lower than the indicated temperature on the thermometer.
- The vehicle speed is greater than 20 km/h (13 MPH).
(This is to prevent the indicated temperature from being affected by engine heat during low-speed driving.)
- The ignition switch has been turned to the OFF position for more than 2 hours. (The engine is cold.)