Turn Signal Lamp Does Not Operate

With CONSULT-II

Select "BCM" on CONSULT-II. With "FLASHER" data monitor, make sure "TURN SIGNAL R" and "TURN SIGNAL L" turns ON-OFF linked with operation of lighting switch.

• When lighting switch is: TURN SIGNAL R ON TURN RH position 
• When lighting switch is: TURN SIGNAL L ON TURN LH position 
  Fig 1: CONSULT-II Display - DATA MONITOR

  Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II

Refer to COMBINATION SWITCH INSPECTION .

OK or NG 

• OK: GO TO 2.
• NG: Check lighting switch. Refer to COMBINATION SWITCH INSPECTION .

With CONSULT-II

1. Select "FLASHER" during active test. Refer to ACTIVE TEST  .
2. Make sure "FLASHER RIGHT" and "FLASHER LEFT" operate.

Without CONSULT-II

GO TO 3.

OK or NG 

• OK: Replace BCM. Refer to REMOVAL AND INSTALLATION OF BCM .
• NG: GO TO 3.
  Fig 2: CONSULT-II Display - ACTIVE TEST

  Courtesy of NISSAN MOTOR CO., U.S.A.

1. Turn ignition switch OFF.
2. Disconnect BCM connector and front turn/fog lamp LH and RH connectors.
3. Check continuity between BCM harness connector M20 terminal 60 (G/B) and front turn/fog lamp LH harness connector E101 terminal 2 (G/B).
   • 60 (G/B) - 2 (G/B): Continuity should exist. 
4. Check continuity between BCM harness connector M20 terminal 61 (G/Y) and front turn/fog lamp RH harness connector E102 terminal 2 (G/Y).
   • 61 (G/Y) - 2 (G/Y): Continuity should exist. 

OK or NG 

• OK: GO TO 4.
• NG: Repair harness or connector.
  Fig 3: Checking Continuity Between BCM Harness And Front Turn/Fog Lamp RH Harness

  Courtesy of NISSAN MOTOR CO., U.S.A.

1. Check continuity between front turn/fog lamp LH harness connector E101 terminal 3 (B) and ground.
   • 3 (B) - Ground: Continuity should exist. 
2. Check continuity between front turn/fog lamp RH harness connector E102 terminal 3 (B) and ground.
   • 3 (B) - Ground: Continuity should exist. 

OK or NG 

• OK: GO TO 5.
• NG: Repair harness or connector.
  Fig 4: Checking Continuity Between Front Turn/Fog Lamp RH Harness Connector E102 Terminal 3 And Ground

  Courtesy of NISSAN MOTOR CO., U.S.A.

Check bulb standard of each turn signal lamp is correct.

OK or NG 

• OK: Replace BCM if turn signal lamps do not work after setting the connector again. Refer to REMOVAL AND INSTALLATION OF BCM .
• NG: Replace turn signal lamp bulb.