Remote Keyless Entry System Operation

Power is supplied at all times

Through 50A fusible link (letter f , located in the fuse and fusible link box)
To BCM (body control module) terminal 70
Through 10A fuse [No. 19, located in the fuse block (J/B)]
To combination meter terminal 8.

Ground is supplied

To BCM (body control module) terminal 67 and
To combination meter terminal 17
Through grounds M57, M61 and M79.

When the remote keyless entry system is triggered by input from the key fob, BCM (body control module) output turn signal from BCM (body control module) terminals 60 and 61, interpreting it as turn signal is ON.

The BCM supplies power

From terminals 60 and 61
To front turn/fog lamp LH and RH terminal 2
Through front turn/fog lamp LH and RH terminal 3
To grounds E9, E15 and E24, and
To rear turn signal lamp LH terminal 1
Through rear turn signal lamp LH terminal 3
To grounds B7 and B19, and
To rear turn signal lamp RH terminal 1
Through rear turn signal lamp terminal 3
To grounds B117 and B132.

BCM (body control module) sends signal to combination meter through CAN communication lines, and turns on turn signal indicator lamps within combination meter.

With power and input supplied, the BCM controls the flashing of the hazard warning lamps when key fob is used to activate the remote keyless entry system.