Rear Turn Signal Lamp Does Not Operate

Check bulb standard of each turn signal lamp is correct.

OK or NG 

• OK: GO TO 2.
• NG: Replace turn signal lamp bulb.

1. Disconnect BCM connector and rear turn signal lamp connector.
2. Check continuity between BCM harness connector M20 terminal 61 (G/Y) and rear turn signal lamp RH harness connector B105 terminal 1 (G/Y).
   • 61 (G/Y) - 1 (G/Y): Continuity should exist. 
3. Check continuity between BCM harness connector M20 terminal 60 (G/B) and rear turn signal lamp LH harness connector B35 terminal 1 (G/B).
   • 60 (G/B) - 1 (G/B): Continuity should exist. 

OK or NG 

• OK: GO TO 3.
• NG: Repair harness or connector.
  Fig 1: Checking Continuity Between BCM Harness And Rear Turn Signal Lamp LH Harness

  Courtesy of NISSAN MOTOR CO., U.S.A.

Check continuity between rear turn signal lamp harness connector B35 LH and B105 RH terminal 3 (B) and ground.

• 3 (B) - Ground: Continuity should exist. 
  Fig 2: Checking Continuity Between Rear Turn Signal Lamp Harness And B105 RH Terminal 3 And Ground

  Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

• OK: Check rear turn signal lamp connector for proper connection. Repair as necessary.
• NG: Repair harness or connector.