Wheel Alignment Inspection: Toe-In

Measure toe-in using following procedure. If out of specification, inspect and replace any damaged or worn rear suspension parts.

1. Bounce rear of vehicle up and down to stabilize the posture.
2. Push vehicle straight ahead about 5 m (16 ft).
3. Put a mark on base line of the tread (rear side) of both tires at the same height of hub center. These are measuring point.
4. Measure distance "A" (rear side).
   Fig 1: Measuring Point

   Courtesy of NISSAN MOTOR CO., U.S.A.
5. Push vehicle slowly ahead to rotate wheels 180 degrees (1/2 turn).

   If wheels have rotated more than 180 degrees (1/2 turn), try the above procedure again from the beginning. Never push vehicle backward.

6. Measure distance "B" (front side).

   Standard value 

   Total toe-in: Refer to " SERVICE DATA  ". 

   Fig 2: Toe-In Distance

   Courtesy of NISSAN MOTOR CO., U.S.A.
7. If outside the standard value, adjust with adjusting bolt in rear lower link.
   CAUTION: Be sure to adjust equally on RH and LH side with adjusting bolt.
   Fig 3: Rear Lower Link Adjusting Bolt

   Courtesy of NISSAN MOTOR CO., U.S.A.