LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2004 >> G35 x >> Repair and Diagnosis >> Suspension >> Rear Suspension >> 2004 - Rear Suspension - Sedan >> Rear Suspension Member >> Removal and Installation >> Removal >> Notes

Removal and Installation: Removal: Notes

  1. Remove tire with power tool.
  2. Remove brake caliper with power tool. Hang it in a place where it will not interfere with work. Refer to BRAKE SYSTEM - SEDAN - 2004 .
    NOTE: Avoid depressing brake pedal while brake caliper is removed.
  3. Remove rear exhaust tube. Refer to EXHAUST SYSTEM - SEDAN - 2004 .
  4. Remove stabilizer bar. Refer to STABILIZER BAR .
  5. Remove drive shaft. Refer to REAR PROPELLER SHAFT .
  6. Remove final drive. Refer to REAR FINAL DRIVE - COUPE & SEDAN - 2004 .
  7. Separate the attachment between parking brake cable and vehicle and rear suspension member. Refer to PARKING BRAKE SYSTEM - SEDAN - 2004 .
  8. Remove rear lower link and coil spring. Refer to REAR LOWER LINK & COIL SPRING .
  9. Remove fixing bolt in lower side of shock absorber.
  10. Set jack under rear suspension member.
  11. Remove mounting bolts and nuts of member stay from vehicle.
  12. Remove mounting nuts of mount stopper.
  13. Slowly lowering jack, then remove rear suspension member, suspension arm, radius rod, front lower link and axle from vehicle as a unit.
  14. Remove fixing bolts and nuts, then remove suspension arm, front lower link, radius rod from rear suspension member.
scientia non olet · About LEMON Manuals