Power Supply and Ground Circuit Check for Compass

CHECK FUSE
Check 10A fuse [No. 12, located in fuse block (J/B)].

OK or NG
1. OK: GO TO 2.
2. NG: If fuse is blown, be sure to eliminate case of problem before installing new fuse. Refer to POWER SUPPLY ROUTING CIRCUIT .
CHECK POWER SUPPLY CIRCUIT
1. Disconnect compass connector.
2. Turn ignition switch ON.
3. Check voltage between compass harness connector M81 terminal 4 (Y/G) and ground.
  Battery voltage should exist.
  
  Fig 1: Checking Voltage Between Compass Harness Connector M81 Terminal 4 (Y/G) And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: GO TO 3.
2. NG: Check harness for open or short between compass and fuse.
CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Check continuity between compass harness connector M81 terminal 1 (B) and ground.
  
  Fig 2: Checking Continuity Between Compass Harness Connector M81 Terminal 1 (B) And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG

Continuity should exist.
1. OK: INSPECTION END
2. NG: Repair or replace harness for ground circuit.