Power Supply and Ground Circuit Check for Compass

Check 10A fuse [No. 12, located in fuse block (J/B)].

OK or NG 

1. OK: GO TO 2.
2. NG: If fuse is blown, be sure to eliminate case of problem before installing new fuse. Refer to POWER SUPPLY ROUTING CIRCUIT .

1. Disconnect the compass connector.
2. Turn ignition switch ON.
3. Check voltage between compass harness connector M81 terminal 4 (Y/G) and ground.
   1. Battery voltage should exist. 

OK or NG 

1. OK: GO TO 3.
2. NG: Check harness for open or short between compass and fuse.

Fig 1: Checking Voltage Between Compass Harness Connector Terminal And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Turn ignition switch OFF.
2. Check continuity between compass harness connector M81 terminal 1 (B) and ground.
   1. Continuity should exist. 

OK or NG 

1. OK: Inspection end.
2. NG: Repair or replace harness for ground circuit.

Fig 2: Checking Continuity Between Compass Harness Connector Terminal And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.