Turn Signal Lamp Does Not Operate

CHECK BULB
Check bulb standard of each turn signal lamp is correct.

OK or NG
1. OK: GO TO 2.
2. NG: Replace turn signal lamp bulb.
CHECK COMBINATION SWITCH INPUT SIGNAL
With CONSULT-II

Select "BCM" on CONSULT-II. With "FLASHER" data monitor, make sure "TURN SIGNAL R" and "TURN SIGNAL L" turns ON-OFF linked with operation of lighting switch.

When lighting switch is TURN RH position: TURN SIGNAL R ON

When lighting switch is TURN LH position: TURN SIGNAL L ON

With out CONSULT-II

Refer to COMBINATION SWITCH INSPECTION .

OK or NG
1. OK: GO TO 3.
2. NG: Check lighting switch. Refer to COMBINATION SWITCH INSPECTION .
  
  Fig 1: Identifying "TURN SIGNAL R" And "TURN SIGNAL L" Turns ON-OFF Linked With Operation Of Lighting Switch
  Courtesy of NISSAN MOTOR CO., U.S.A.
ACTIVE TEST
With CONSULT-II
1. Select "FLASHER" during active test. Refer to ACTIVE TEST .
2. Make sure "FLASHER RIGHT" and "FLASHER LEFT" operates.
  Turn signal lamp should operate
With out CONSULT-II

GO TO 4.

OK or NG
1. OK: Replace BCM. Refer to REMOVAL AND INSTALLATION OF BCM .
2. NG: GO TO 4.
  
  Fig 2: Identifying "FLASHER RIGHT" And "FLASHER LEFT" Operates
  Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK SHORT CIRCUIT

Turn ignition switch OFF.
Disconnect BCM connector and all turn signal lamp connectors.

Check continuity (short circuit) between harness connector of BCM and ground.

TERMINAL SPECIFICATION

Terminals				Continuity
	BCM				Ground
	Connector		Terminal (Wire color)
RH	M2	46 (PU/W)	No
LH	M2	45 (G/W)	No

OK or NG

OK: Replace BCM if turn signal lamps does not work after setting the connector again. Refer to REMOVAL AND INSTALLATION OF BCM .
NG: Repair harness or connector.

Fig 3: Checking Continuity (Short Circuit) Between Harness Connector Of BCM And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.