Turn Signal Lamp Does Not Operate

Check bulb standard of each turn signal lamp is correct.

OK or NG 

1. OK: GO TO 2.
2. NG: Replace turn signal lamp bulb.

With CONSULT-II

Select "BCM" on CONSULT-II. With "FLASHER" data monitor, make sure "TURN SIGNAL R" and "TURN SIGNAL L" turns ON-OFF linked with operation of lighting switch.

1. When lighting switch is TURN RH position: TURN SIGNAL R ON 
2. When lighting switch is TURN LH position: TURN SIGNAL L ON 

Fig 1: CONSULT-II Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

With out CONSULT-II

Refer to "COMBINATION SWITCH INSPECTION ".

OK or NG 

1. OK: GO TO 3.
2. NG: Check lighting switch. Refer to "COMBINATION SWITCH INSPECTION ".

With CONSULT-II

1. Select "FLASHER" during active test. Refer to "ACTIVE TEST  ".
2. Make sure "FLASHER RIGHT" and "FLASHER LEFT" operate.
   1. Turn signal lamp should operate 

With out CONSULT-II

GO TO 4.

OK or NG 

1. OK: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".
2. NG: GO TO 4.

Fig 2: Active Test Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Turn ignition switch OFF.
2. Disconnect BCM connector and all turn signal lamp connectors.
3. Check continuity (short circuit) between harness connector of BCM and ground.

Fig 3: Continuity Check (Short Circuit) Between Harness Connector Of BCM And Ground Table

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 4: Checking Continuity (Short Circuit) Between Harness Connector Of BCM And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK: Replace BCM if turn signal lamps does not work after setting the connector again. Refer to "REMOVAL AND INSTALLATION OF BCM ".
2. NG: Repair harness or connector.