Washer Operation
- When wiper switch is in rear wiper washer position, BCM detects rear wiper washer signal by BCM wiper switch reading function (Refer to COMBINATION SWITCH READING FUNCTION
), and combination switch (wiper switch) ground is supplied;
- To Rear Washer Motor Terminal 2
- Through Combination Switch (Wiper Switch) Terminal 13
- To Combination Switch (Wiper Switch) Terminal 12
- Through Body Grounds M35, M45 And M85.
- With ground supplied, rear washer motor is operated.
- When BCM detects that rear washer motor has operated for. 0.4 seconds or linger, BCM operates rear wiper motor low speed.
- When BCM detects washer switch is OFF, low speed operation cycles approximately 3 times and then stops.